About the authors

« Colors missing on model after Stress Analysis | Main | Add model iProperty to the drawing Revision Table »

11/01/2012

Comments

Feed You can follow this conversation by subscribing to the comment feed for this post.

Could you perhaps just post the code (as a .txt), or a file created with an earlier version of Inventor?

I'm still on 2012.

Thanks a lot!

Hi,

Yes you're right. I attached the code as text at the end of the article.

The comments to this entry are closed.

RSS Feed

  • Subscribe

January 2016

Sun Mon Tue Wed Thu Fri Sat
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31            

Self-Service Kiosk

Did not find what you were looking for?
Give the Inventor Self-Service Kiosk a try and hit the Start button
Note: the kiosk momentarily only works with Internet Explorer
kiosk