In Inventor 2012, if you use a Semi-Isolated project created in a previous version, open an assembly and change the browser from Model to File Status, the browser nodes icons of assembly document and part component could display incorrectly.
The problem does not exist if you create Semi-Isolated project from scratch in 2012.
While our development is working for fixing the problem, to avoid it, perform the steps below.
- In the Project editor, change the project type from Semi-Isolated to Single > Save.
- Change the project type back to Semi-Isolated > Save.
In case, after restarting Inventor, it loses the icons again, you need to repeat the steps above.
Ale
Subscribe
Comments