Stress Analysis and Thin parts

You are performing a stress analysis on a part and you receive the following error, even if the Constraints and the Material have been defined correctly:

“Improper constraints, material or mesh”.

 

If this happens with a thin part, you need to set a smaller value for the Average Element Size in the Mesh Settings.

 

By default the value is 0.100.

Average Element Size controls the size of the mesh according to the formula below:

Size of average mesh = longest parameter of object x Average Element Size.

Note: A smaller average element will take a longer time to analyze.

Ale

Comments

[sewing machine reviews]

Perhaps more important, I believe that the methods used in this analysis of the Voynich mystery can be applied to difficult questions in other areas.